1-4 l Introduction
This manual applies to the CHS series of Conair granulators.
Model nos. CHS-810, CHS-814, CHS-819, and CHS-824 specify the size of the
cutting chamber.
Supplementary designations specify:
Read the Manual before installing and using the machine.
Be careful when the knives are accessible, they are sharp, and
can cause personal injury!
• These Conair granulators are designed for granulating injection
molded, blow molded and extruded plastic parts and scrap.
• The size and performance of the granulators are designed to suit
the type of waste material.
• Approval must be obtained from Conair for granulating other
products and materials for the warranty conditions to apply.
• The granulators are designed so that maintenance and cleaning can
be done quickly and easily, both routine maintenance and changing
of materials.
• All service must be done by trained service personnel.
• This Manual contains instruction for both handling and service.
• Chapter 7 contains instructions directed towards service personnel.
• Chapter 11 contains accessory equipment for the machine.
• Other Sections contain instructions for the operator.
• The granulators are delivered with an Instruction Manual and
touch-up paint.
• Any modifications or conversions of the machines must be
approved by Conair. This is to prevent injuries. The machine
warranty and product assurance would otherwise be rendered void.
• Please address any queries to the local Conair representative or
Conair customer service.