Filter
Top Products
NOTE: The knives must butt up against the rings on the outer edges
of the cutter housing.
• Make sure that the knives butt up against the rear of the knife attachment.
• Tighten the fastening screws, tightening torque 162.26lb-ft (220 Nm).
• Re-check that the knife clearance is 0.008 - 0.012 in. (0.20 - 0.30 mm).
Check against both the front and rear fixed knives.
• Re-check that the knives butt up against the outer edges of the
cutter housing.
• Install the remaining pairs of knives in the same way.
✐
11-4 l Accessories