Carrier 30XA080-500 Fan User Manual


  Open as PDF
of 80
 
71
Table 8 — 30XA140-500 Electrical Data, Dual Point (High Ambient Option)
LEGEND
NOTES:
1. Units are suitable for use on electrical systems where voltage supplied to the unit
terminals is not below or above the listed minimum and maximum limits. Maximum
allowable phase imbalance is: voltage, 2%; amps 10%.
2. Cooler heater is wired into the control circuit so it is always operable as long as the
control power supply disconnect is on, even if any safety device is open.
3. For MCA that is less than or equal to 380 amps, 3 conductors are required.
For MCA between 381-760 amps, 6 conductors are required.
For MCA between 761-1140 amps, 9 conductors are required.
For MCA between 1141-1520 amps, 12 conductors are required.
Calculation of conductors required is based on 75 C copper wire.
4. Wiring for main field supply must be rated 75 C minimum. Use copper for all units.
a. Incoming wire size range for the terminal block is no. 4 AWG (American Wire Gage)
to 500 kcmil.
b. Incoming wire size range of non-fused disconnect with MCA up to 599.9 amps is
3/0 to 500 kcmil.
c. Incoming wire size range of non-fused disconnect with MCA from 600 to 799.9 amps
is 1/0 to 500 kcmil.
d. Incoming wire size range of non-fused disconnect with MCA from 800 to 1199.9 amps
is 250 kcmil to 500 kcmil.
5. Data provided circuit 1/circuit 2 where there are two circuits.
UNIT
30XA
UNIT VOLTAGE
NUMBER
OF
COND
FANS
NO HYDRONIC PACKAGE 5 HP PUMP, 3450 RPM CONTROL CIRCUIT
V-Hz
(3 Ph)
Supplied
MCA MOCP
ICF Rec
Fuse
Size
MCA MOCP
ICF Rec
Fuse
Size
Voltage
1 PH,
60 Hz
MCA
and
MOCP
Min Max WD XL WD XL
140
230-60 207 253 6/4 383.8/211.9 600/ 300 660.8/391.2 — 450/250 383.8/227.9 600/350 660.8/407.2 — 450/300 115 40
200-60 187 220 6/4 422.6/233.3 700/ 350 756.7/447.8 — 500/300 422.6/251.0 700/350 756.7/465.5 — 500/300 115 40
460-60 414 506 6/4 191.9/105.9 300/ 150 330.4/195.6 962.4/ 566.6 225/125 191.9/113.9 300/175 330.4/203.6 962.4/574.6 225/150 115 40
575-60 518 633 6/4 147.7/ 81.4 225/ 125 263.9/156.3 769.9/ 453.3 175/100 147.7/ 87.8 225/125 263.9/162.7 769.9/459.7 175/110 115 40
380-60 342 418 6/4 223.9/124.0 350/ 200 400.2/237.1 1165.2/ 686.1 300/150 223.9/133.7 350/200 400.2/246.8 1165.2/695.8 300/175 115 40
160
230-60 207 253 6/4 434.8/249.1 700/ 400 828.8/391.2 — 600/300 434.8/265.1 700/400 828.8/407.2 — 600/350 115 40
200-60 187220 6/4 478.1/273.9 800/ 450 950.7/447.8 — 600/350 478.1/291.6 800/450 950.7/465.5 — 600/350 115 40
460-60 414 506 6/4 216.9/124.1 350/ 200 414.4/195.6 1222.4/ 566.6 300/150 216.9/132.1 350/200 414.4/203.6 1222.4/574.6 300/175 115 40
575-60 518 633 6/4 167.0/ 95.9 250/ 150 331.9/156.3 977.9/ 453.3 200/125 167.0/102.3 250/150 331.9/162.7 977.9/459.7 200/125 115 40
380-60 342 418 6/4 253.3/145.4 400/ 225 501.2/237.1 1480.2/ 686.1 300/175 253.3/155.1 400/250 501.2/246.8 1480.2/695.8 300/200 115 40
180
230-60 207 253 6/6 383.8/383.8 600/ 600 660.8/660.8 — 450/450 — — — — — 115 40
200-60 187 220 6/6 422.6/422.6 700/ 700 756.7/756.7 — 500/500 — — — — — 115 40
460-60 414 506 6/6 191.9/191.9 300/ 300 330.4/330.4 962.4/ 962.4 225/225 — — — — — 115 40
575-60 518 633 6/6 147.7/147.7 225/ 225 263.9/263.9 769.9/ 769.9 175/175 — — — — — 115 40
380-60 342 418 6/6 223.9/223.9 350/ 350 400.2/400.2 1165.2/1165.2 300/300 — — — — — 115 40
200
230-60 207 253 6/6 434.8/434.8 700/ 700 828.8/828.8 — 600/600 — — — — — 115 40
200-60 187220 6/6 478.1/478.1 800/ 800 950.7/950.7 — 600/600 — — — — — 115 40
460-60 414 506 6/6 216.9/216.9 350/ 350 414.4/414.4 1222.4/1222.4 300/300 — — — — — 115 40
575-60 518 633 6/6 167.0/167.0 250/ 250 331.9/331.9 977.9/ 977.9 200/200 — — — — — 115 40
380-60 342 418 6/6 253.3/253.3 400/ 400 501.2/501.2 1480.2/1480.2 300/300 — — — — — 115 40
220
230-60 207 253 7/6 515.9/434.8800/ 700 839.6/828.8 — 700/600 — — — — — 115 40
200-60 187 220 7/6 567.8/478.1 800/ 800 962.6/950.7 — 700/600 — — — — — 115 40
460-60 414 506 7/6 258.0/216.9 400/ 350 419.8/414.4 1227.8/1222.4 350/300 — — — — — 115 40
575-60 518 633 7/6 198.8/167.0 300/ 250 336.2/331.9 982.2/ 977.9 250/200 — — — — — 115 40
380-60 342 418 7/6 301.0/253.3 500/ 400 507.8/501.2 1486.8/1480.2 400/300 — — — — — 115 40
240
230-60 207 253 7/6 515.9/505.1 800/ 800 839.6/828.8 — 700/600 — — — — — 115 40
200-60 187 220 7/6 567.8/555.8800/ 800 962.6/950.7 — 700/700 — — — — — 115 40
460-60 414 506 7/6 258.0/252.6 400/ 400 419.8/414.4 1227.8/1222.4 350/300 — — — — — 115 40
575-60 518 633 7/6 198.8/194.5 300/ 300 336.2/331.9 982.2/ 977.9 250/250 — — — — — 115 40
380-60 342 418 7/6 301.0/294.5 500/ 450 507.8/501.2 1486.8/1480.2 400/350 — — — — — 115 40
260
460-60 414 506 9/6 349.1/216.9 500/ 350 626.6/414.4 1848.6/1222.4 450/300 — — — — — 115 40
575-60 518 633 9/6 268.6/167.0 450/ 250 500.9/331.9 1478.9/ 977.9 350/200 — — — — — 115 40
380-60 342 418 9/6 406.2/253.3 600/ 400 758.8/501.2 2237.8/1480.2 500/300 — — — — — 115 40
280
460-60 414 506 9/7 349.1/258.0 500/ 400 626.6/419.8 1848.6/1227.8 450/350 — — — — — 115 40
575-60 518 633 9/7 268.6/198.8 450/ 300 500.9/336.2 1478.9/ 982.2 350/250 — — — — — 115 40
380-60 342 418 9/7 406.2/301.0 600/ 500 758.8/507.8 2237.8/1486.8 500/400 — — — — — 115 40
300
460-60 414 506 10/6 411.0/252.6 600/ 400 632.0/414.4 1854.0/1222.4 500/300 — — — — — 115 40
575-60 518 633 10/6 315.9/194.5 500/ 300 505.2/331.9 1483.2/ 977.9 400/250 — — — — — 115 40
380-60 342 418 10/6 478.9/294.5 800/ 450 765.4/501.2 2244.4/1480.2 600/350 — — — — — 115 40
325
460-60 414 506 9/9 349.1/349.1 500/ 500 626.6/626.6 1848.6/1848.6 450/450 — — — — — 115 40
575-60 518 633 9/9 268.6/268.6 450/ 450 500.9/500.9 1478.9/1478.9 350/350 — — — — — 115 40
380-60 342 418 9/9 406.2/406.2 600/ 600 758.8/758.8 2237.8/2237.8 500/500 — — — — — 115 40
350
460-60 414 506 9/9 405.6/349.1 600/ 500 626.6/626.6 1848.6/1848.6 500/450 — — — — — 115 40
575-60 518 633 9/9 311.6/268.6 500/ 450 500.9/500.9 1478.9/1478.9 400/350 — — — — — 115 40
380-60 342 418 9/9 472.4/406.2 800/ 600 758.8/758.8 2237.8/2237.8 600/500 — — — — — 115 40
400
460-60 414 506 8/12 343.7/461.1 500/ 600 621.2/622.9 1843.2/1430.9 450/600 — — — — — 115 50
575-60 518 633 8/12 264.2/355.2 400/ 450 496.6/492.7 1474.6/1138.7 350/400 — — — — — 115 50
380-60 342 4188/12 399.7/537.9 600/ 700 752.3/744.6 2231.3/1723.6 500/600 — — — — — 115 50
450
460-60 414 506 8/14 400.2/560.2 600/ 800 621.2/781.2 1843.2/2003.2 500/700 — — — — — 115 50
575-60 518 633 8/14 307.3/430.7 500/ 600 496.6/619.9 1474.6/1597.9 400/500 — — — — — 115 50
380-60 342 4188/14 465.8/652.8 700/ 800 752.3/939.2 2231.3/2418.2 600/800 — — — — — 115 50
500
460-60 414 506 8/14 400.2/608.8 600/ 800 621.2/829.7 1843.2/2051.7 500/700 — — — — — 115 50
575-60 518 633 8/14 307.3/468.0 500/ 600 496.6/657.3 1474.6/1635.3 400/600 — — — — — 115 50
380-60 342 4188/14 465.8/709.3 700/1000 752.3/995.7 2231.3/2474.7 600/800 — — — — — 115 50
ICF — Instantaneous Current Flow
MCA — Minimum Circuit Amps
MOCP — Maximum Overcurrent Protection
WD — Wye-Delta
XL — Across-the-Line
 previous next