Arizona MAX-5000XL Humidifier User Manual


 
AZI Customer Service 800-528-7411 or 602-470-1414 Page 49 of 92
Oven Cleaning
This selection is the start of an oven cleaning process that burns off most
residue build-up in the oven. Use a fume hood to remove possible toxic
emissions from the
work place. Similar to
the self-cleaning mode
in a home oven, the process turns the
heating elements on to reach an oven
temperature of 550º
C in less than 22
minutes. The oven temperature will be
maintained for a total oven cleaning
time of 45 minutes from start to finish.
The heat generated makes the top of
the instrument hotter than normal.
Extreme caution should be used to
prevent injury until the instrument has
cooled down at the conclusion of the
cleaning cycle. During the cleaning cycle, there may be smoke, odor, and possible
toxic emissions produced by the instrument. This is normal as the residue is burned
off the oven lining. Use a fume hood to remove the fumes and smoke from the work
place. Consult the MSDS on your sample materials to determine the content of the
emissions.
For a complete description of the oven cleaning procedure, see section beginning on
page 80.
Cleaning Reminder Setup
A CLEANING REMINDER is available
to remind you to clean the oven
regularly. The default factory settings
are:
ENABLE - No
TIME 00:00
INTERVAL - 0 Weeks
To turn the prompt on or off, or
adjust the interval, go to the Main
Test Screen and select in order: MENU, CALIBRATION MENU, OVEN SELF
CLEANING, and CLEANING REMINDER SETUP.
Enable Toggle to YES to enable the prompt or NO to prevent the prompt from
appearing.
Time The time the prompt is to appear, usually the start of the shift (using a
24 hour format).
Interval The interval between calibrations (in weeks). If the interval is set to
“00”, the reminder will occur daily.