Filter
Top Products
AZI Customer Service 800-528-7411 or 602-470-1414 Page 15 of 92
All accessory equipment, printer, computer, etc., should be connected before applying
power to the instrument. See the following sections, 4.4 and 4.5, to connect a printer
and/or computer.
Plug the line cord into a dedicated electrical power outlet. Line noise on the power lines
may affect accuracy. A dedicated AC power line or an isolation transformer for the MAX
5000XL may be beneficial in eliminating this noise.
Turn the instrument on by pressing the switch on the back of the analyzer next to the
power receptacle.
After displaying the opening screen for about five seconds, the main test screen shown
below will appear. (It may be necessary to press ESC to clear any calibration reminders).
The keypad functions are:
The Left and Right Arrow Keys move the cursor
one space left or right in edit mode or to the next
field on some input screens. They move the
highlight bar one page at a time when selecting
stored memory starts or stored data test results.
(Stored data is not available on all instruments)
The Up and Down Arrow Keys move the cursor
up and down through lists in edit mode. They move the highlight bar one line
at a time when selecting stored memory starts, stored data, or lines on input
screens.
The Alphanumeric Keys toggle through the listed characters plus a blank
space.
The ENT Key selects most functions. Other functions are selected with keys
below the screen. As operating modes change, the function of the keys below
the display change. The function performed by the key is displayed and
changed with operating mode changes.
The ESC Key is used to exit menus. Many functions that are Yes/No or On/Off
type selections will be saved when the ESC Key is depressed. If the field is
editable with numbers or letters, the ESC key allows an abort without changing
contents