Filter
Top Products
AZI Customer Service 800-528-7411 or 602-470-1414 Page 16 of 92
After power-up, the balance temperature will be stabilized for high temperature
testing, which may take up to 2 hours. Wait for the balance temperature stability
icon on the main screen to change from unstable to stable before performing
the balance calibration or low moisture/solids/ash testing (<1%). See section 6.1
Balance Temperature Stability on page 64 for more information.
4.3. Contrast Adjustment
If necessary, adjust the display
contrast controls for better viewing of
the display. The left most soft key
below the display has the word
CONTRAST above it. Press this key
and the display changes to instructions
on setting contrast. Use the up and
down arrows on the key pad until the
display is acceptable and press the
[ESC] key to save the setting and exit
back to the Main Test Screen.
The LCD will darken after a few
minutes of inactivity but will brighten
with any key press.
4.4. Connecting a Printer
An optional graphic capable printer is available from AZI (pictured
is printer example only). It connects to the parallel printer port at
the rear of the instrument. The content and time of printing for
each report can be custom configured from the menu system.
These same reports can be directed to a computer through the
RS-232 serial port at the back of the instrument.
Unpack the printer and cable. Load the paper according to
the instructions in the printer manual. Plug the large end
cable connector into its mating socket on the
printer, and the small end into its mating socket on
the back of the MAX 5000XL. Plug the power cord
into the printer, and into a GROUNDED power
receptacle.
Turn the printer power on. (On some older
printers, it is also necessary to place the printer
“On Line.”)
NOTE: The USB and AUX ports are not active at present. They will
be implemented in later revisions to the instrument.