Filter
Top Products
AZI Customer Service 800-528-7411 or 602-470-1414 Page 34 of 92
Use This Test Weight For Total Calculations?
Toggle this parameter to YES
if this test’s starting weight is to
be used in Total Result
calculations for this or later
linked tests. The starting
weight for this test will be used
for total calculations until
another YES is encountered.
Note the starting weight of the
first test in a linked series is used for total calculations until a YES is
encountered.
Purity Factor – Toggle this
parameter to YES if a value,
provided by the user, is to be
entered as a parameter for the
purity calculation. The default
number is 4.778, which is the
purity factor for gypsum. The purity result is Purity Factor times the Moisture loss.
Allow Moisture Gain - When testing some materials, the linked test option is
used. The first test is the free moisture test, which drives off any free moisture.
However, some materials if already dried might actually collect moisture during this
test. With the Allow Moisture Gain enabled, the collected moisture will be reported.
Ending Criteria for this test is usually “Rate or Time”. If “Rate” is used the test
would never end if the sample gained moisture.