Filter
Top Products
14
Install the SCSI Software
Once the SCSI interface card is installed in a PCI slot, your computer must locate and
install the SCSI cards software drivers. The scanner and the scanning software will
not work if the SCSI cards software drivers are not installed immediately after
installing the card. You can disregard this section if your computer already has a SCSI
port.
Windows 95/98, Windows NT 4.0, and Macintosh operating systems each have a
different driver installation procedure, so follow the instructions below for your
operating system. The scanner software comes on two CD-ROMs: one for Windows
and one for the Macintosh. Make sure you have the correct CD-ROM for your
operating system.
If Youre Running Windows 95 or Windows 98 . . .
Depending on how your computer system was originally set up, you may be asked to
insert your Windows operating system CD-ROM during the SCSI software
installation process. Please have your Windows CD-ROM handy in case it is needed.
Follow these steps to install the SCSI driver:
1. Turn off your scanner, then turn on your computer. During the Windows
start-up sequence, a screen appears saying that your system has detected new
hardware.
2. Click
Next
. You see the screen to the right.
3. Make sure
Search for the best driver for
your device
is selected. Insert the Windows
EPSON Perfection 1200 CD-ROM in your
drive, then click
Next
.