Filter
Top Products
11
Set the SCSI ID Number
The scanner is preset at the factory to SCSI ID 2. If you need to change this number,
turn the scanner off. Then use the tip of a small flathead screwdriver to turn the rotary
switch on the back panel. Be sure to choose a unique number that doesnt conflict
with the ID number of other SCSI devices (including the SCSI interface board itself,
which is usually ID 7).
Dont use SCSI ID 8 or 9 for your scanner; these are for
factory use only.
If youre installing either of the scanner options, see Transparency Unit on page 67
or Auto Document Feeder on page 73.