Filter
Top Products
12
Connect the Scanner to Your Computer
Before you begin, make sure the scanner, computer, and any
SCSI devices connected to your computer are turned off. The
scanner is off when the
P
operate button is out (not pushed
down below the surface of the panel).
1. Locate the SCSI cable that came with your scanner.
2. Squeeze the lock releases on the cable connector and plug the cable into either
SCSI connector on the back of the scanner. The cable is secure when both
connector locks snap in. Then connect the other end to the SCSI port on your
computer or another SCSI device in the chain, and tighten the screws to secure
the cable.
If you are using a cable other than the one provided, the
length of the cable must not exceed 9.8 feet (3 meters). If you
are connecting multiple SCSI devices, the total length of the
SCSI bus (cables) must not exceed 19.7 feet (6 meters);
otherwise the system may not work properly