Filter
Top Products
13
3. Locate the SCSI terminator switch at the rear of the scanner. If the scanner is the
only SCSI device in the chain or if its the last device in the chain, leave the
terminator turned on. Turn the terminator switch off if youve connected your
scanner in the middle of a SCSI chain.
Do not use an external terminator.
4. Plug in the power cables for your computer, scanner, and other external SCSI
devices.
Power On Your Scanner and System
Always turn your scanner and other SCSI devices on before you turn on the
computer. Otherwise, the computer may not recognize your EPSON scanner when
you install your software. The operate light on the top of the scanner blinks as the
scanner initializes. Once the scanner is turned on, power on your computer system.
Whenever you turn off the scanner, wait at least 10 seconds
before turning it back on. Rapidly turning the scanner on and
off can damage the scanner.
ON
SW