Filter
Top Products
CommunicationsTeledyne API – Model T300/T300M CO Analyzer
Teledyne Analytical Instruments 161
To assign or reset the status flag bit assignments, press:
SAMPLE RANGE=50.0 PPM CO= XX.XX
<TST TST> CAL SETUP
DEL deletes the
character currently
inside the cursor
brackets.
Press the [?] button repeatedly to cycle
through the available character set: 0-9
NOTE: Values of A-F can also be set
but are meaningless.
The <CH and CH>
buttons move the
cursor brackets “[ ]”
left and right along the
bit string.
SETUP X.X HESSEN STATUS FLAGS
<SET EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2 EXIT
SETUP X.X HESSEN VARIATION:TYPE1
<SET SET> EDIT EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
Continue pressing NEXT until ...
SETUP X.X SOURCE WARNING:0004
NEXT EDIT PRNT EXIT
SETUP X.X BOX TEMP WARNING:[0]008
<CH CH> DEL [0] ENTR EXIT
SETUP X.X SAMPLE TEMP WARNING:0020
PREV NEXT EDIT PRNT EXIT
Continue pressing NEXT until desired
flag message is displayed
EXIT discards the
new setting.
ENTR accepts the
new setting.
6.7.3.5. INSTRUMENT ID
Each instrument on a Hessen Protocol network must have a unique identifier (ID
number). If more than one GFC7001T/GFC7001TM analyzer is on the Hessen network,
refer to Section 5.7.1 for information and to customize the ID of each.