Filter
Top Products
2150EX Area Velocity Flow Module
Section 2 Preparation and Installation
2-26
Figure 2-19 Connecting the AV Sensor
3. Align and insert the connector. The sensor release will click
when the sensor connector is fully seated.
4. Connect the two caps together.
Important Information
Regarding "X" Marking
The ATEX labeling on the sensor’s serial tag shows a number
ending in "X". The X marking indicates that there are special
conditions that must be met to ensure safety, as explained on
page vi in the front of this manual.
CAUTION
The AV2150EX sensor is labeled and X-marked for special
usage conditions in order to prevent static electricity. Avoid
conditions that may generate a static charge, such as rubbing
the AV2150EX with static producing cloth.
Figure 2-20 AV2150EX Sensor Cable Labels
Sensor Release
Caps
X-Marking
WARNING
ELECTROSTATIC HAZARD
DO NOT RUB
CLEAN WITH DAMP CLOTH ONLY