Filter
Top Products
2150EX Area Velocity Flow Module
Section 2 Preparation and Installation
2-15
The charging terminals are located on the circuit board mounted
on the inside of the left compartment door (Figures 2-8 and 2-9, +
and –). A cable ending in alligator clips may be connected to these
terminals for charging.
CAUTION
The circuit board is permanently connected to the interior of
the module. Use care when opening the case that the wires
are not damaged.
During charging, the yellow LED on the circuit board remains on
to indicate charge voltage in correct polarity. The replaceable 2A
fuse on the back side of the board protects against excessive
current.
Figure 2-8 Location of 2196EX charging terminals
Desiccant holder
(remove screws to
access desiccant
Rechargeable, non-
replaceable lead-acid
batteries
Charge terminals
(remove screws to
access fuse)
–
+