Filter
Top Products
Error & Status Messages on the Control Panel
75
4
P=07 I=9Fc01234 Power Off
On
/If Error Reoccur Call Service
A controller error. The SC
number indicates the prob-
lem.
Turn the power switch off and
then on. If the message ap-
pears again, contact your sales
or service representative.
Paper Invalid for Du-
plex:Tray#
/Change Setting or Form
Feed
The printer detected the set-
ting of the indicated tray is
invalid for Duplex Tray. #:
tray number
Change the setting of the indi-
cated paper input tray or ap-
ply Form Feed using another
tray, or press {
{{
{Job Reset}
}}
}.
Punch-hole Chips are Full The Punch Chips is full of
punch chips.
Remove the punch chips from
the punch wast box.
See p.102 “Removing Punch-
hole Chips”
When the message appears
even the punch wast box is
not full, remove the Punch-
hole chips on the top of the
punchwast box.
See ⇒ p.102 “When the mes-
sage appears even after re-
moving the Punch-hole chips”
Remove MisfeedA:Internal
Path
/See Instructions in Front
Cover
There is a misfeed in the print-
er.
Remove the misfed paper fol-
lowing the instructions inside
the front cover.
For more information, see
p.92 “When "Remove Misfeed
A:Internal Path" Appears”.
Remove MisfeedB: Fusing
Unit
/See Instructions in Front
Cover
There is a misfeed in the fus-
ing unit.
Remove the misfed paper fol-
lowing the instructions inside
the front cover.
For more information, see
p.92 “When "Remove Misfeed
B: Fusing Unit" Appears”.
Remove MisfeedR: Finisher
/Open Front Cover
There is a misfeed in the fin-
isher.
Open the finisher cover and
remove misfeed.
For more information, see
p.94 “When "Remove Misfeed
R: Finisher" Appears”.
Remove MisfeedW: Mailbox
/Open Mailbox Cover
There is a misfeed in the out-
put 4-bin tray.
Open the mailbox cover and
remove misfeed.
For more information, see
p.94 “When "Remove Misfeed
W: Mailbox" Appears”.
Messages/Second messages Description Solution
JupP1k_GB_Mainte_F_FM.book Page 75 Thursday, August 22, 2002 4:23 PM