Filter
Top Products
31
2. Cleaning and Adjusting the
Printer
Cautions to Take When Cleaning
R
WARNING:
R
CAUTION:
Clean the printer periodically to maintain fine printing.
Dry wipe the exterior with a soft cloth. If dry wiping is not enough, wipe with a
soft, wet cloth that is wrung out well. If you still cannot remove the stain or
grime, use a neutral detergent, then wipe over with a well-wrung wet cloth, dry
wipe, and let it dry.
Important
❒ To avoid deformation, discoloration, or cracking, do not use volatile chemi-
cals, such as benzine and thinner, or spray insecticide on the printer.
❒ If there is dust or grime inside the printer, wipe with a clean, dry cloth.
• Do not remove any covers or screws other than those spec-
ified in this manual. Some parts of the machine are at a high
voltage and could give you an electric shock. Also, if the ma-
chine has laser systems, direct (or indirect) reflected eye
contact with the laser beam may cause serious eye damage.
When the machine needs to be checked, adjusted, or re-
paired, contact your service representative.
• Do not take apart or attempt any modifications to this ma-
chine. There is a risk of fire, electric shock, explosion or loss
of sight. If the machine has laser systems, there is a risk of
serious eye damage.
• When removing misfed paper, do not touch the fusing section be-
cause it could be very hot.
JupP1k_GB_Mainte_F_FM.book Page 31 Thursday, August 22, 2002 4:23 PM