Filter
Top Products
Figure 39. Video Search Tab
46 C3663M-B (11/09)
SEARCH TAB
When you play back recorded video from the Event History or Recorded Video page, the Search tab appears in place of the Cameras tab (refer to
Figure 39). The Search tab allows you to filter the video so you can view images of specific interest. The following options can be found within
this tab:
• All Frames: Plays back all images in the selected video clip.
• Motion Frames: Plays
back only those images that exhibit motion.
• Alarm Frames: Plays back only those images that were recorded during an alarm event.
• Motion and Alarm Fra
mes: Plays back only those images that exhibit motion and were recorded during an alarm event.
• Man
ually Recorded Frames: Plays back only those images recorded using the Manual Record button on the Video Controls tab.
• Smart Search: P
lays back images that exhibit motion in a user-defined area of the video pane. Refer to Smart Search for details.
Options to play back motion, alarm, or manually recorded video are available only if the selected video segment contains images re
corded in that
manner.
SMART SEARCH
The smart search feature allows you to further filter video recorded based on the occurrence of motion. For example, you can search for video in
which one small portion of a camera view that exhibits motion.
NOTE: Smart Search is not available on all IP cameras.
Complete the following steps to
configure a smart search:
1. Perform a search on the Event History or Recorded Video page. Play back a video segment as described earlier in this section.
2. Select the video pane of the camera on which you want to perform a smart search.
3. On the Search tab, select Smart Search. This activates several options and buttons on the Search tab.
4. Select Show Smart Search Mask. Select a color for the mask
by clicking the Mask Color box and selecting Change Mask Color.