Filter
Top Products
Appendix 3. PLC Development Environment using GPPQ
3.5 PLC Program Development Procedure
- 448 -
3.5.3 Ladder Read from the C64 Controller
The method of reading a ladder from the M600 controller to the GPPQ is explained below.
(1) Menu Selection
The screen is selected from the menu using the following GPPQ basic operation.
( GRPH )
Mode screen
Menu
A
lt
PC
2
PC menu
window
1
Read
PC read
screen
(2) Screen Operation
The file names are designated and executed on the following screen.
File name designation method
Input the file name stored in the read target memory.
Display the read target memory list screen by pressing Ctrl + D .
Display the file list screen by pressing Ctrl + L .
After selecting the file using ↑ and ↓ , display the file name selected in the file name
designation column by pressing Enter .
[Read from PC]
Execute(Y)
Ctrl+L : filelist Ctrl+D : directo Space : sele Esc : close
Interface
Target PC
Target Mem
Cancel(N)
RS232C <---> QnACPU
Network : 0 Station : FF PC Type : Q4A
Internal RAM Title [ ]
1. File 1. File Name [ ] Title [ ]
1. [ * ] Parameter
2. [ * ] Seq/SFC Prog
3. [ ] Device Comment
4. [ ] Dev Init Value
5. [ ] Simulation Data
6. [ ] File Register
1. [ ] Internal
1. ( * ) Whole Range
2. ( ) Step Range [ ] – [ ]
3. ( ) Step Range P [ ] – [ ]
4. ( ) Block Range [ ] – [ ]
1. ( * ) Whole Range
2. ( ) Specify ZR[ ] – [ ]
1. ( * ) Whole Range
2. ( ) Specify Detail Range
2. Device Mem
2. Tgt
[Restrictions]
The following options of [2. Tgt] under [1. File] can be selected.
[2. Seq/SPC Prog] and [1. Whole Range], [3. Device Comment]