Filter
Top Products
35
ADDING ADDITIONAL USER CODES
✦ The Control Panel can be programmed with fi ve
restricted user codes and one page alert user code.
✦ The restricted user codes operate the system as
usual, but cannot access Setup Mode.
✦ The restricted user codes can access a special
Code Mode that can be used to change or
remove any of the fi ve restricted user codes, the
page alert user code, or the duress code.
✦ The page alert user code dials the supervisory
number (programmed for a pager) when it is
used to arm or disarm the system.
✦ A restricted user code is appropriate to give any
user that should be restricted from programming
the Control Panel.
✎ NOTE: For maximum security, a 3-5 digit code is
recommended.
✎ WARNING: NEVER PROGRAM ANY RESTRICTED
USER CODE THE SAME AS THE MASTER USER CODE!
STEPS #93-98 Create any additional user codes using these
steps then log the codes in the boxes to the right.
REMOVING ADDITIONAL USER CODES
STEPS #93-98 Any additional user code can be removed
from the Control Panel by entering the
appropriate step number and pressing TEST.
✦ Because access to programming would be
impossible without a master user code, it cannot be
removed using these steps. The master user code
can be changed using programming STEP #99.
✎ NOTE: The master user code can be set to the
factory default using the Control Panel master
reset programming step, although all other system
programming will be reset to factory values and all
sensors programmed will be erased.
CONTROL PANEL MASTER RESET
✦ Master resetting the Control Panel will set all of the
programming options back to the factory values.
The master user code will be reset to 1234.
✎ CAUTION: Master resetting the Control Panel will erase
the user codes and remove all programmed sensors.
All Control Panel and communicator programming
values will be reset to the factory defaults.
1. Start with the system in Test Mode (Setup Mode
cannot be reached from any other mode).
2. From Test Mode, enter the master user code then
press TEST.
✴ A “Gong” and fi ve “Beeps” will sound, signaling that the
system is in Setup Mode.
3. Enter programming STEP #999 then press TEST.
4. Enter 999 again then press TEST again.
✴ A “Bing” will sound to indicate the beginning of the reset
process. This process will take up to 10 seconds while
the memory is being reset.
✦ The system will revert to the fi rst time power-
up condition and the new master user code
will be 1234. Go to the “Basic Control Panel
Programming” section of this manual to begin re-
programming the system.
PROGRAMMING STEP #93-98
ENTERS STEP NUMBER
1-5 DIGIT ADDITIONAL
USER CODE
(3-5 DIGITS RECOMMENDED)
STORES CODE - 1 BING
PROGRAMMING STEP #93-98
REMOVES CODE - 1 BING
93 = RESTRICTED CODE 1
94 = RESTRICTED CODE 2
95 = RESTRICTED CODE 3
96 = RESTRICTED CODE 4
97 = RESTRICTED CODE 5
98 = PAGE ALERT USER CODE
ENTER FOR STEP #
MASTER USER CODE
ENTERS TEST MODE
1 GONG & 5 BEEPS
STEP #999
FOR MASTER
RESET
ENTER 999 TO OK
THE MASTER RESET
START IN TEST
DONE
USE THESE EXAC
T
KEYSTROKES
TO PERFORM A
MASTER RESET
ENTERS STEP NUMBER
PRESS TEST, 1 BING SOUNDS,
WAIT ABOUT 10 SECONDS
STEP CODE FUNCTION CODE ENTERED
STEP #93 RESTRICTED USER CODE #1
STEP #94 RESTRICTED USER CODE #2
STEP #95 RESTRICTED USER CODE #3
STEP #96 RESTRICTED USER CODE #4
STEP #97 RESTRICTED USER CODE #5
STEP #98 PAGE ALERT USER CODE