Filter
Top Products
26
✦ Adding additional sensors will increase the
protection provided by the system.
✦ All ground-level perimeter openings and
accessible upper-story openings need protection.
✦ Motion detectors can protect interior areas and
areas where valuables are kept.
ADDING SENSORS TO THE SYSTEM
1. Always start with the system in Test Mode (enter
a user code and press TEST).
2. Enter the master user code then press TEST.
✴ A “Gong” and fi ve “Beeps” will sound.
✴ The sensor status indicators will light for each sensor
programmed into the Control Panel.
3. Enter an unused sensor number from 01-24 (you
must enter two digits, example: 5 = 05).
✎ NOTE: A sensor can be programmed into more
than one location. Be sure to choose an UNUSED
sensor number. If a sensor gets entered into more
than one location, delete the duplicates using the
remove sensor function.
✴ The sensor status indicator light will fl ash for the sensor
number selected.
4. Activate the sensor. (To add a wireless keypad,
press the keypad's
key.)
✴ A “Bing” tone will sound when the sensor is programmed
into the Control Panel and the sensor status indicator will
stay lit.
✴ A “Buzz” tone will sound if there is already another
sensor programmed to that sensor number.
5. Enter another sensor number, or exit Setup Mode
by pressing the
key then press OFF for three
seconds.
REMOVING SENSORS FROM THE SYSTEM
✦ If a previously programmed sensor isn't going
to be used with the system anymore, or it's a
duplicate that has been entered into more than
one sensor location, it should be removed from
the Control Panel's memory.
1. Start with the system in Test Mode.
2. Enter the master user code then press TEST.
✴ A “Gong” and fi ve “Beeps” will sound.
✴ The sensor status indicators will light for each sensor
programmed into the Control Panel.
3. Enter the sensor number (from 01-24) that
you want to remove (you must enter two digits,
example: 5 = 05).
✴ The sensor status indicator light will fl ash for the sensor
number selected.
4. Press TEST.
✴ A “Bing” tone will sound when the sensor has been
removed and the sensor status indicator will turn off.
5. Enter another sensor number, or exit Setup Mode
by pressing the
key then press OFF for three
seconds.
12. CUSTOMIZING THE SYSTEM
START IN TEST
MASTER
USER
CODE
1 GONG & 5 BEEPS
(SETUP MODE)
NEW SENSOR
NUMBER
1 BING AND
SENSOR
INDICATOR
LIGHTS
REPEAT OR EXIT
ACTIVATE
SENSOR
SENSOR
INDICATOR
FLASHES
START IN TEST
MASTER
USER
CODE
1 GONG & 5 BEEPS
(SETUP MODE)
NUMBER OF
SENSOR TO
REMOVE
REPEAT OR EXIT
SENSOR
INDICATOR
FLASHES
REMOVES
SENSOR
1 BING & SENSOR
INDICATOR
DARK