Filter
Top Products
17
PROGRAMMING DIFFERENT SENSOR TYPES (CONT.)
✦ For DXT-61, DXT-21, DXS-21, DXT-41, &
DXS-62A single-button remotes, simply press the
unit's button.
✎ NOTE: After the Control Panel recognizes the
transmitter, single-button remotes must be
re-programmed as “panic buttons” or home
automation controllers. Refer to Page 28 in the
“Customizing the System” section of this manual.
✦ For DXT-23, DXS-23, & DXT-42 multi-button
remotes: Learn the transmitter by pressing the
left button. The remote will arm the Control Panel
with the left button and disarm with the right
button. Labels are provided with the DXT-42 for
identifying the buttons.
✎ NOTE: After the Control Panel “learns” the
transmitter, multi-button remotes can easily be
re-programmed to have the left button arm/disarm
the Control Panel and the right button activate/
deactivate the Home Automation output. Refer
to the “Advanced Programming” section of this
manual.
For All Models:
✴ A single “Bing” tone will sound and the sensor status
indicator will stay lit when the sensor is programmed into
the Control Panel.
✴ A “Buzz” tone will sound if there is already another
sensor programmed to that sensor number.
✦ Exit Setup Mode by pressing the
key then
press OFF for three seconds. Reminder: The
system will automatically exit the Setup Mode
and return to Off Mode after three minutes of
keypad inactivity.
✎ NOTE: To remove sensors from the Control Panel's
memory, see Page 26 in the “Customizing the
System” section of this manual.
DXT-21
SEND SIGNAL WITH LEFT BUTTON
LEFT = ARM/DISARM
RIGHT = DISARM
BOTH = EMERGENCY
DXT-42