Filter
Top Products
30
CHANGING A SENSORS SUPERVISION
✦ When a wireless sensor is programmed, the
Control Panel automatically sets it to supervised
or non-supervised. The hardwire loops are always
supervised for end-of-line resistor termination.
✦ The Control Panel expects hourly status
transmissions from any wireless sensor
programmed as supervised.
✦ Any wireless sensor can be programmed as
supervised or non-supervised using this process.
✎ NOTE: Don't program a wireless sensor that
doesn't send status transmissions as supervised.
CHANGING A SENSORS RESTORE REQUIREMENTS
✦ When a wireless sensor is programmed, the
Control Panel automatically recognizes it as
manual or automatic restoring. The hardwired
loops are always manual restoring.
✦ The Control Panel expects restoral signals from any
wireless sensor programmed as manual restore.
✦ Any wireless sensor can be programmed as
manual or automatic restore using this process.
✎ NOTE: Don't program a wireless sensor that doesn't
send restoral transmissions as manual restore.
ENTRY DELAY TIME
✦ The factory-set Entry Delay time is 30 seconds.
STEP #25 The Entry Delay time can be adjusted from 20 to
255 seconds using this step. Write the new Entry
Delay time in the User's Guide.
✎ NOTE: Don't make the Entry Delay too short. The
user may not have enough time to disarm the
system before an alarm.
EXIT DELAY TIME
✦ The factory-set Exit Delay time is 60 seconds.
STEP #26 The Exit Delay time can be adjusted from 20 to
255 seconds using this step. Write the new Exit
Delay time in the User's Guide.
BURGLARY SIREN TIME
✦ The factory-set burglary siren time is fi ve minutes
(UL installation maximum).
STEP #30 The burglary siren time can be adjusted from one
to 30 minutes using this step.
EMERGENCY SIREN TIME
✦ The factory-set emergency siren time is fi ve
minutes (UL installation maximum).
STEP #31 The emergency siren time can be adjusted from
one to 30 minutes using this step.
NUMBER OF
SENSOR
TO CHANGE
SENSOR INDICATOR
FLASHES
ENTERS SENSOR NUMBER
18 FOR MANUAL RESTORE
19 FOR AUTO RESTORE
STORES CHANGE
1 BING AND SENSOR
INDICATOR LIT
NUMBER OF
SENSOR
TO CHANGE
SENSOR INDICATOR
FLASHES
ENTERS SENSOR NUMBER
16 FOR NON-SUPERVISED
17 FOR SUPERVISED
STORES CHANGE
1 BING AND SENSOR
INDICATOR LIT
PROGRAMMING
STEP #25
ENTERS STEP NUMBER
TIME IN SECONDS 20 - 255
STORES VALUE - 1 BING
PROGRAMMING STEP #26
ENTERS STEP NUMBER
TIME IN SECONDS
20 - 255
STORES VALUE - 1 BING
PROGRAMMING STEP #30
ENTERS STEP NUMBER
TIME IN MINUTES
1 - 30
STORES VALUE - 1 BING
PROGRAMMING
STEP #31
ENTERS STEP NUMBER
TIME IN MINUTES 1 - 30
STORES VALUE - 1 BING