Linear DUAL 824 Home Security System User Manual


 
24
TEST MODE
Even though this is a self-monitoring supervised
system, the National Burglar and Fire Alarm
Association recommends that all security
systems be tested manually on a regular basis.
1. The system must be in Off Mode before
switching to Test Mode.
2. Switch the system into Test Mode by entering a
user code and pressing TEST.
When the system is switched to the Test Mode, the
keypad(s) will sound a “Gong” and four “Beeps”.
3. Holding down the TEST button in Test Mode will
light all of the keypad’s indicators.
The sensor status indicators will fl ash for each sensor
programmed into the Control Panel.
4. Go to each sensor and press its test button or
open and close the protected opening.
5. To test the wireless keypad, press the wireless
keypad’s
key.
The keypad(s) will make a “Bing” sound as each sensor
is tested, followed by 1-3 beeps indicating signal strength
with 3 beeps being the strongest signal.
As each sensor is tested, the sensor status indicator for
the sensor will stop fl ashing and return to showing the
current status of the sensor.
6. Continue testing until there are no fl ashing
sensor status indicators.
SENSOR OPERATION IN EACH SYSTEM MODE
SENSOR FUNCTION OFF MODE CHIME MODE HOME MODE AWAY MODE
AUTOMATION ACTIVATES AND DEACTIVATES THE AUTOMATION OUTPUT
EMERGENCY ARMED 24-HOURS - TRIGGERS EMERGENCY ALARM
PANIC ARMED 24-HOURS - TRIGGERS SILENT PANIC ALARM
FIRE ARMED 24-HOURS - TRIGGERS FIRE ALARM
PERIMETER DEACTIVATED CHIME INSTANT BURGLARY ALARM
EXIT/ENTRY DEACTIVATED CHIME DELAYED BURGLARY ALARM
INTERIOR DEACTIVATED DEACTIVATED DEACTIVATED
INSTANT BURGLARY ALARM UNLESS
ACTIVATED DURING AN ENTRY
DELAY, THEN IT IS DELAYED
CHIME CHIME
2-BUTTON ARM/DISARM (LEFT)
2-BUTTON AUTOMATION (RIGHT)
EMERGENCY (BOTH BUTTONS)
LEFT BUTTON SWITCHES SYSTEM TO AWAY MODE †
IF ALARM MEMORY IS ACTIVE, SWITCHES SYSTEM TO OFF MODE ‡
LEFT BUTTON SWITCHES SYSTEM TO OFF MODE ‡
2-BUTTON ARM (LEFT)
2-BUTTON DISARM (RIGHT)
EMERGENCY (BOTH BUTTONS)
LEFT BUTTON SWITCHES SYSTEM TO AWAY MODE †
IF ALARM MEMORY IS ACTIVE, SWITCHES SYSTEM TO OFF MODE ‡
RIGHT BUTTON SWITCHES SYSTEM TO OFF MODE ‡
ENVIRONMENTAL ARMED 24-HOURS - TRIGGERS ANNUNCIATION ONLY
INTERIOR HOME DEACTIVATED DEACTIVATED INSTANT BURGLARY ALARM
NOTE: If the system is left unattended in Test
Mode, it will automatically switch back to Off Mode
after three minutes.
When directly connecting (without a telephone
line) to the DUAL 824 with the RA-2400 remote
access software (Version 1.3 or later), press the
EMERGENCY key while in Test Mode to cause the
control panel to connect to the modem.
START IN OFF MODE
(OPTIONAL)
YOUR
USER
CODE
1 GONG
& 4 BEEPS
DONE
TEST MODE
SENSOR FUNCTION TABLE
CAN BE HOME MODE USING PROGRAMMING STEP 50
‡ CAN BE CHIME MODE USING PROGRAMMING STEP 51