Filter
Top Products
34
AUTOMATION OUTPUT WHILE ARMED
✦ The factory setting causes the Control Panel's
Automation Output to activate when pressing the
key, or when it's triggered with a two-button
remote control.
STEP #73 The Control Panel can be programmed to
activate the Automation Output when the system
is armed as well as when normally triggered
using this step.
AUTOMATION OUTPUT DURING EXIT/ENTRY DELAYS
✦ The factory setting causes the Control Panel's
Automation Output to activate when pressing the
key, or when it's triggered with a two-button
remote control.
STEP #74 The Control Panel can be programmed to
activate the Automation Output during the exit
and Entry Delays as well as when normally
triggered using this step.
AUTOMATION OUTPUT POLARITY
✦ The factory setting causes the Control Panel's
Automation Output to provide a current limited
voltage source when activated.
STEP #75 The Control Panel can be programmed so the
Automation Output provides a current limited
voltage source when deactivated using this step.
REMOTE ACCESS PASSWORD
✦ This password is used to gain access to the Control
Panel when using the RA-2400 remote access
software. The password must be 6-digits long.
STEP #87 Use this step to enter a new remote access
password then log the password in the box
below.
DURESS CODE
✦ The duress code will disarm the system, without
any special indications or sounds, but will send
the programmed duress code to the Central
Station. The code should be two or more digits
different than any user code
STEP #92 Use this step to enter the duress code then log
the code in the box below.
MASTER USER CODE
✦ The master user code is 1234 when power is fi rst
applied to the Control Panel.
✦ The master user code can be changed to any
1-5 digit code. Only the master user can access
Setup Mode, restricted users cannot.
✎ NOTE: For maximum security, a 3-5 digit code is
recommended.
STEP #99 Use this step to enter the new master user code
then log the code in the box below.
PROGRAMMING
STEP #73
ENTERS STEP NUMBER
0 FOR STANDARD TRIGGER
1
FOR OUTPUT WHEN ARMED
STORES VALUE - 1 BING
PROGRAMMING STEP #74
ENTERS STEP NUMBER
0
FOR STANDARD TRIGGER
1 FOR OUTPUT DURING
EXIT/ENTRY DELAYS
STORES VALUE - 1 BING
PROGRAMMING
STEP #75
ENTERS STEP NUMBER
0 FOR VOLTAGE WHEN OFF
1
FOR VOLTAGE WHEN ON
STORES VALUE - 1 BING
PROGRAMMING
STEP #87
ENTERS STEP NUMBER
6-DIGIT REMOTE
ACCESS PASSWORD
STORES PASSWORD - 1 BING
REMOTE ACCESS PASSWORD:
PROGRAMMING STEP #92
ENTERS STEP NUMBER
1-5 DIGIT DURESS CODE
(3-5 DIGITS RECOMMENDED)
STORES CODE - 1 BING
DURESS CODE:
MASTER USER CODE:
PROGRAMMING STEP #99
ENTERS STEP NUMBER
1-5 DIGIT MASTER CODE
(3-5 DIGITS RECOMMENDED)
STORES CODE - 1 BING