Filter
Top Products
16
PROGRAMMING DIFFERENT SENSOR TYPES
✦ Follow the instructions on the previous page to
select a sensor number to program the sensor
into.
✎ NOTE: A sensor can be programmed into more
than one location. Be sure to choose an UNUSED
sensor number. If a sensor gets entered into more
than one location, delete the duplicates using the
remove sensor function.
✦ To add DXS-10 wireless keypads, press and hold
the keypad's key until programmed into the
Control Panel.
✦ For DXS-31 and DXS-32 door/window sensors,
move the magnet away from the side of the
sensor.
✎ IMPORTANT NOTE: The DXS-31 & DXS-32 door/
window sensors are pre-set at the factory for
delayed burglary response. If the sensor is going
to be used on a non-entry portal (window, sliding
glass door, etc.) a jumper can be changed in the
sensor to select instant response. The jumper
should be changed before programming the
sensor so the Control Panel will assign the sensor
to the proper sensor function. See the “Basic
Sensor Installation” section of this manual or the
sensor’s instructions for details on changing the
jumper.
✦ For DXS-81, DXS-91, DXS-54, DXS-73,
& accessory sensors, simply send a test
transmission (refer to the sensor's instructions for
details on sending a test transmission).
DXS-10
DXS-32
DXS-81