Operating/Maintenance Tips
CHANGING THE POWER NOZZLE BELT
After extended use, the Power Nozzle Belt on your Sentria
™
system may become stretched and worn causing the belt to
slip.(See page 11 - Brush Roll Performance Indicator Light.) If
this condition exists, simply replace the old belt with a new one.
NOTE: Use only approved Kirby
®
belts.
To change the belt, remove the nozzle from the Sentria
system. Then release the belt tension by using the han-
dle on the Belt Lifter (20) to turn it all the way to the
right (clockwise) until the green arrows line up. >
2
Unlock the Rug Plate (26) by unhooking the two latches
on the rear of the nozzle. >
3
Pull on the rear edge of the Rug Plate to remove from
the nozzle.
Note the Brush Roll Bristle Height Adjustment setting
(1,
2, or 3).
Lift out the Belt and Brush Roll. >
4
Slide off the old belt and replace with a new one.
55
1