Filter
Top Products
Optional Accessories
USING THE CARPET SHAMPOO SYSTEM (cont)
As you move the Sentria
™
system back and forth, foam will
be released and the brush will work it into the carpet.
NOTE: Suds should be dispensed the full width of the
tray when the unit is pulled backward. If not, pull back
more slowly or check and clean the Shampoo Tank Filter,
if necessary (see page 35).
After suds have been on the carpet at least five minutes,
pick up the foam by turning the Shampoo Tank to the OFF
position. With the unit at its lowest height level, move the
Shampooer over the foam until the foam is picked up. Some
moisture will accumulate in the front of the tray. Once the
carpet is thoroughly dry, vacuum with the Kirby
®
Upright. •
CLEANING THE CARPET SHAMPOO
SYSTEM
1
3
Push the Toe-Touch Control Bottom Pedal (9) all the
way down to raise the nozzle and tray, then turn the
Sentria system OFF and unplug it. >
2
Turn the Suds Control Valve fully to the left
(counter-clockwise) to the OFF position.
Pull the Small Flexible Hose from the Shampoo
Tank. >
Raise the Headlight Hood (21). Release the belt by
turning the Belt Lifter to the left (counter-clockwise)
until the red arrows line up. >
33