Filter
Top Products
Optional Accessories
USING THE HANDI-BUTLER TOOL IN THE
HAND-HELD MODE
The Handi-Butler Tool Hand-Held Mode gives the user
maximum flexibility when cleaning and polishing an item.
1
To use the Handi-Butler tool in the hand-held mode,
begin with the hose attached to the front of your
Sentria
™
system. >
For ease of use, attach the bit to the Flexible Shaft (B)
before assembling the Handi-Butler tool.
Rotate the tip of the Flexible Shaft (B) until the hole in the tip
lines up with the hole in the grip section. Insert the long end
of the Angled Key (D) into the holes. >
3
Use the enclosed Mini Wrench (E) to loosen the silver
rotating tip at the end of the Flexible Shaft (B). >
Do not bend the Flexible Shaft (B) to a radius less than 2 inches,
it will over heat and fail.
/!\ WARNING:
Do not bend the Flexible Shaft (B) to a radius less than 2 inches,
it will over heat and fail.
/!\ WARNING:
Do not remove end ferrule while tool is running.
/!\ CAUTION:
Safety Glasses (F) should be worn when using the Handi-Butler tool.
49
2