Kirby Sentria Vacuum Cleaner User Manual


 
Optional Accessories
FLOOR BUFFER SET-UP (cont)
5
Place the hooks located on the rear of the nozzle over
the Attaching Bar (24) and push the nozzle up against
the Sentria™ system.
Turn the Accessory Lock (22) all the way to the right
(clockwise) to lock the nozzle in place. >
6
To engage the drive belt and Buffer Brush, use the
handle to turn the Belt Lifter all the way to the right
(clockwise) until the green arrows line up. Lower the
Headlight Hood (21).>
7
DO NOT USE Tech Drive
®
power assist with the
Floor Buffer.
Place Tech Drive power assist in Neutral by stepping on
the gray "N" side ("N" for Neutral) of the Tech Drive N/D
Pedal (11). >
Because the unit moves forward when the Floor Buffer
Brush touches the floor, make sure the Buffer Nozzle
is on its highest setting. Press the Toe-Touch Control
Bottom Pedal (9) all the way down to raise the Buffer
Nozzle all the way up.
While holding onto the unit's handle, turn the Sentria
system ON. >
To avoid losing control of the Buffer when brush is on the floor surface,
hold on to the handle before plugging the power cord into the wall outlet
and before turning the power switch ON. To avoid possible damage to
soft tiles or marking of waxed and finished non-carpeted floors,
disengage the Tech Drive power assist pedal.
/!\ CAUTION:
To avoid losing control of the Buffer when brush is on the floor surface,
hold on to the handle before plugging the power cord into the wall outlet
and before turning the power switch ON. To avoid possible damage to
soft tiles or marking of waxed and finished non-carpeted floors,
disengage the Tech Drive power assist pedal.
To avoid losing control of the Buffer when brush is on the floor surface,
hold on to the handle before plugging the power cord into the wall outlet
and before turning the power switch ON. To avoid possible damage to
soft tiles or marking of waxed and finished non-carpeted floors,
disengage the Tech Drive power assist pedal.
40
USING THE FLOOR BUFFER
8