Filter
Top Products
Optional Accessories
CARPET SHAMPOO SYSTEM SET-UP (cont)
5
While sliding the Carpet Shampoo System Nozzle/
Tray Assembly toward the Sentria
™
system and over
the Motor Shaft (23), connect the hooks on the bottom
rear of the nozzle to the Attaching Bar (24). >
Push the nozzle up against the unit and turn the
Accessory Lock (22) to the right (clockwise) to lock
the nozzle in place. To engage the belt, use the handle
on the Belt Lifter to turn it all the way to the right
(clockwise) until the green arrows line up. Then lower
the Headlight Hood (21). >
7
The Shampoo Tank is removable and should be filled
or emptied at your sink.
NOTE: The Shampoo Tank is removed and re-attached
in the same way as the Mini Em-Tor® collector (see
page 10 for details).
Unscrew the large cup from the top of the Shampoo Tank
and turn the Suds Control Valve fully to the left (counter-
clockwise) to OFF.
Holding the Shampoo Tank level, fill it to the full line with
warm water (not hot).
Using the large cup from the top of the tank, pour three
cupfuls of Kirby
®
Carpet Shampoo into the Shampoo Tank.
Do not use more, as over-foaming will result.
NOTE: One tankful of solution will clean about a 10x12
foot carpet (3x3.5m). Larger carpets will require refilling the
Shampoo Tank.
Replace the large cup into the opening on top of the
Shampoo Tank. >
31
6