Filter
Top Products
Optional Accessories
USING THE FLOOR BUFFER (cont)
9
Press the Toe-Touch Control Upper Pedal (8) to lower
the brush one notch at a time. Lower the brush as far
as the Toe-Touch Control will allow.
With the Buffer running, move the Sentria
™
system over
the floor as though you were cleaning a carpet, using slow,
steady strokes.
NOTE: The belt should not be stretched when stored for
an extended period. Make sure the green arrows line up
for storage. •
HARD FLOOR PAD
See page 16 for set-up and use of the Hard Floor Pad. •
Your Kirby
®
Floor Buffer can also be used as a Carpet
Fluffer to reset the nap on a matted-down carpet.
Before fluffing the carpet, raise the nozzle all the way
up by pushing the Toe-Touch Control Bottom Pedal (9)
all the way down.
Place the cleaner on the carpet to be fluffed. >
2
Plug in the Power Cord. Disengage the Tech Drive
®
power assist by pressing on the gray "N" side of the
Tech Drive N/D Pedal (11).
Holding onto the handle firmly, start the cleaner by pressing
the ON switch. >
41
USING THE CARPET FLUFFER
1