Filter
Top Products
Optional Accessories
5
Now you are ready to attach a tool to the 6" Rotator
Shaft. Rotate the tip of the Rotator Shaft (C) until
the hole in the tip lines up with the hole in the grip
section. Insert the long end of the Angled Key (D)
into the holes. >
6
Use the enclosed Mini Wrench (E)to loosen the silver
rotating tip at the end of the Rotator Shaft (C). >
7
Select one of the cleaning or polishing tools and insert
into the tip of the Rotator Shaft (C). Firmly tighten the
tip to secure the tool in place with the Mini Wrench (E).
Remove the Angled Key (D). >
8
Screw the end of the Rotator Shaft (C) onto the
Handi-Butler tool (A) making sure the prong in the
center of the Rotator Shaft fits into the center of the
Handi-Butler tool. >
9
To avoid accidental starting, make sure the air inlet
openings on the Handi-Butler tool (A) are CLOSED
before turning your Sentria
™
system on.
Turn your Sentria system on. Then, rotate the Air Valve on
the Handi-Butler tool (A) to expose the two air-inlet open-
ings. You are now ready to gently polish and clean. Allow
the speed of the tool to do all the work. Avoid putting exces-
sive pressure on the spinning tool. •
52