Filter
Top Products
BES-961BC • BES-1261BC
93
Chapter 5 Setting
Thread Breakage Sensor
Validity or invalidity and sensitivity of the thread breakage sensor can be set.
Setting of sensor validity/invalidity
■ This function is previously set to valid for all heads upon shipment.
1. Press
.
2. Specify the number of a machine head by pressing ten keys and validate or
invalidate the thread breakage sensor.
Pressing the same ten key once again changes between validity and invalidity.
Press to switch over the thread breakage sensor for each head between ON and OFF.
3. Press
END
.
Modified setting is saved and the initial screen or halt screen is displayed again.
Thread Breakage Sensitivity
Sensitivity of the thread breakage sensor can be set.
■ The sensitivity can be set within the range of 1 ~ 100. Sensitivity increases as
the figure decreases.
■ This function is previously set to 10 upon shipments.
1. Press
twice.
2. Select the needle bar for which the sensitivity is modified by pressing .
The number of needle bars changes in the sequence of :
ALL (all needle bars) → 1 → 2 → ... 9 or 12 (max.) → ALL → ...
3. Select by pressing .
Heads with which the sensor is valid