Filter
Top Products
Chapter 6 Operation of Machine
BES-961BC • BES-1261BC
121
The machine head whose MENDING lamp is lit performs embroidering by the preset number stitches.
When it is completed, all the machine heads start normal embroidering operation.
• The MENDING lamps except for the machine
head whose needle thread has been broken
are turned off.
• At this time, the machine head, whose
MENDING lamp is on, performs resewing from
the step-back position while the other machine
heads (with MENDING lamps off) are stopped.
When resewing is completed, the other
machine heads (except those halted or with
bed retracted) also start embroidering.
■ Manual operation
The mending start and end positions can be set for each machine head using the MENDING switch on the
tension plate.
The MENDING lamp is lit when the MENDING
switch of each machine head is flipped up
during standby. Resewing from the step-back
position to this position can be executed.
* When the MENDING switch is flipped up while
the MENDING lamp is off, the lamp is turned
on; when the MENDING switch is flipped up
again while the MENDING lamp is lit, the lamp
is turned off.
Note) The mending end position cannot be set for each
machine head.
When all MENDING lamps are turned on, the
mending end position will be set to the position
where one of the lamps is turned off first.
Note) To cancel the mending end position, turn all the
MENDING lamps are turned on (except for halted
machine heads) .