Filter
Top Products
Chapter 1 Preparation of Embroidery Machine
BES-961BC • BES-1261BC
45
4-5 Bed Retract
When embroidery within the maximum area by mounting the tubular square hoop, there is a
possibility that the hoop interferes with the bed. Retract the bed of several machine heads to
avoid interference. Machine heads with an even number enter a halt status.
Note) The machine heads are numbered 1 ~ 6 from the right side.
No.6
No.4
No.2
e
w
q
1. Loosen two bolts w that secure the bed support q, and move the bolts w to the right and
left.
Note) • The bed is secured by two bolts and supported at three places.
• When loosening the bolts, support the bed by hand.
2. Lower the machine bed e slowly until it comes into contact with the leg.
3. Tighten the bolts w again.
r
This figure shows an example of BES-961BC.
Refer to the same sections for BES-1261BC.