Filter
Top Products
BES-961BC • BES-1261BC
153
Chapter 9 List of Error Codes
Area over
Main(Z) motor lock
Main PCB temperature is too high
Main(Z) motor voltage is too low
Main(Z) motor voltage is too high
Lower shaft CPU error
Thread jammed in rotary hook
Hook motor origin point error
Hook motor standby position error
Hook motor mode error
Hook motor communication error
Hook motor parameter error
Hook motor overheat error
Hook motor overcurrent error
Turn off the power
Thread trimming motor origin point error
E-31
E-32
E-33
E-34
E-36
E-38
E-39
E-3C
E-A1
E-A2
E-A3
E-A4
E-B0
E-B1
E-B2
E-B3
E-B4
E-B5
E-B6
E-B7
E-B8
E-B9
Code Error Measures
Set the embroidering area again or move the hoop to a
sewable position.
Press
STOP
. If the same error occurs frequently, the
spindle mechanism is faulty.
Turn the power off once, then on again. If the same
error occurs again, the spindle motor or main PC board
is faulty.
Press
STOP
.
Check that no lint is tangled in the rotary hook and press
STOP
.
Press
STOP
.
Turn the power off once, then on again. If the same error
occurs again, the lower shaft or fan motor is stopped main
PC board is faulty.
Turn the power off, and check the thread trimming
mechanism. Press
STOP
. If the same error occurs
again, the thread trimming mechanism is faulty.