Filter
Top Products
Chapter 1 Preparation of Embroidery Machine
BES-961BC • BES-1261BC
46
4. Set the needle bar case at the needle bar No. 1. Remove the presser foot r from the retracted
machine bed.
Note) • The head of the retracted bed is stopped.
• When removing the presser foot, align the pulley indication mark 3 first.
• To operate the machine in retract position, set the bed in contact with the legs.
Resetting of bed retract
1. Move the machine bed e little by little until it comes into contact with the bed support q.
2. Loosen two bolts w and insert the bed into the right and left directions, then tighten the bolts
securely again.
3. Mount the presser foot for the reset bed e.
(Refer to "Chapter 8. Standard Adjustment" for mounting the presser foot.)