Filter
Top Products
Chapter 8 Standard Adjustment
BES-961BC • BES-1261BC
149
• The thread trimmer connecting rod B q
has a backlash of about 0.1 ~ 0.2 mm back
and forth. Tighten the two bolts e while
pulling them forward by the backlash
amount.
• Tighten the two bolts e so that the thread
trimmer connecting rods B q and C w
are positioned in a straight line.
5. After adjustment is finished, reset the
emergency stop button.
"Emergency Stopping" disappears.
6. Turn the power switch off once, then on
again. Check that the clearance between
the movable knife r and the fixed knife t
is 1 mm.
7. When adjusting again, follow the step 2 and
after.
q
w
e
* Bad example
1mm
t
r
Toward
this side