Filter
Top Products
BES-961BC • BES-1261BC
52
Chapter 2 Embroidering Procedures
HOOP
FLAT CAP
Selects the flat or cap hoop. This selection should be done before turning the power ON
to the machine. Selection after turning the power ON may damage the hoop.
Moves the hoop.
Step-back or forward is available during suspension, by one stitch every time the switch
is pressed (Use switches only.)
Changes the speed range during embroidering (Use switches only).
Carries out inching of the hoop when the switch is pressed in the inching mode
Move the cursor for selecting sewing data and an icon.
Moves the needle bar. The needle moves by the diameter every time this switch is pressed.
Change to the screen for selecting sewing data.
Operation panel
Contrast volume
Adjusts the screen contrast.
SBUS interface connector
Not used (Do not connects anything.)
RS-232C interface connector
Connect personal computer with BE-100 installed, etc.