Filter
Top Products
Troubleshooting 6-3MN1904
Jog. The axis is jogging. In the Mint help file, see the topics JOG, JOGCOMMAND and
Jog mode.
Offset move. The axis is performing an of fset move.
Positional Move. The axis is performing a linear move. See the Mint keywords MOVEA
and MOVER.
Stop. A STOP command has been issued or the stop input is active.
Axis disabled. The axis/drive must be enabled before operation can continue. See
section 5.3.3. Click the Drive enable button in WorkBench v5.
Suspend. The SUSPEND command has been issued and is active. Motion will be
ramped to zero demand whilst active.
Reverse software or hardware limit. A reverse software limit has been activated.
See AXISERROR and/or AXISSTATUS to determine which applies.
Forward software or hardware limit. A forward software limit has been activated.
See AXISERROR and/or AXISSTATUS to determine which applies.
Firmware being updated (horizontal bars appear sequentially). New firmware is being
downloaded to the NextMove BX
II
.
Initialization error. An initialization error has occurred at power on. See the Error Log or
INITERROR topics in the help file. Initialization errors should not normally occur.
User defined symbols can be made to appear using the Mint keywords LED and LEDDISPLAY.