Filter
Top Products
Operation 5-1MN1904
5.1 Introduction
Before powering the NextMove BX
II
you will need to connect it to the PC using a serial cable
and install the supplied PC software WorkBench v5. This software includes a number of tools
to allow you to configure, tune and program the NextMove BX
II
. If you do not have experience
of software installation or Windows applications you may need further assistance for this stage
of the installation
5.1.1 Connecting the NextMove BX
II
to the PC
Connect the serial cable between a PC serial port (often labeled as “COM”) to the
NextMove BX
II
RS232 connector. WorkBench v5 can scan all the COM ports, so you can use
any port.
5.1.2 Installing the software
The CDROM containing the software c an be found separately within the packaging.
1. Insert the CDROM into the drive.
2. After a few seconds the setup wizard should start automatically. If the setup wizard does not
appear, select Run... from the Windows Start menu and type
d:\start
where d represents the drive letter of the CDROM device (use the correct letter for your
installation).
Follow the on-screen instructions to install WorkBench v5. The setup wizard will copy thefiles
to appropriate folders on the hard drive. The default folder is C:\Program Files\Baldor\MintMT,
although this can be changed during setup.
5.1.3 Starting the NextMove BX
II
If you have followed the instructions in the previous sections, you should have now connected
all the power sources, your choice of inputs and outputs and the serial cable linking the PC
with the NextMove BX
II
.
5.1.4 Preliminary checks
Before you apply power for the first time, it is very important to verify the following:
H Disconnect the load from the motor until instructed to apply a load.
H Inspect all power connections for accuracy, workmanship and tightness.
H Verify that all wiring conforms to applicable codes.
H Ve rify that th e Ne xtMove BX
II
is properly earthed/grounded.
H Check all signal wiring for accuracy.
5 Operation
5