Filter
Top Products
5-8 Operation MN1904
4. If you are going to use the relay, drag the g rey Relay0 icon to t he grey X axis i con on the right
of the screen. To configure multiple axes to u se t he relay, repeat this step for the other axes.
If you a re using a digital output, drag the bright blue OUT icon to the grey X axis icon on the
right of the screen. To configure multiple axes with the same drive enable output, repeat this
step for the other axes.
5. Click Apply at the bottom of the screen. This
sends the output configuration to the
NextMove BX
II
.
5.3.3 Testing the drive enable output
1. On the main WorkBench v5 toolbar, click the
Drive enable button. Click the button again.
Each time you click the button,the drive enable
output is toggled.
When the button is in the pressed (down)
position the drive should be enabled. When the
button is in the raised (up) position the drive
should be disabled.
If this is not working, or the action of the button is reversed, check the electrical
connections between the NextMove BX
II
and the drive. If you are using the relay output,
check that you are using the correct normally open or normally closed connection.
If you are using a digital output, check that it is using the correct high or low output
expected by the drive.