Filter
Top Products
Operation 5-7MN1904
4. Click in the Scale box and type a value.
5. Click Apply.
This immediately sets t he scaling factor for the
selected axis. It will remain in the
NextMove BX
II
until another scale is defined,
or power is removed.
5.3.2 Setting the drive enable output
The drive enable output allows NextMove BX
II
to disable the drive in the event of an error.
Each axis can be configured with its own drive enable output, or can share an output with
other axes. If an output is shared, an error on any of the axes sharing the output will cause all
of them to be disabled.
The drive enable output can either be a digital output or the relay.
1. In the Toolbox, click the Digital I/O icon.
2. At the bottom of the Digital I/O screen, click t he
Digital Outputs tab.
The left of the screen shows two yellow icons,
High and Low. These describe how the output
should behave when activated (to enable the
axis).
3. If youare goingto use the r elay,ignore this step
and go straight to step 4.
If you are going to use a digital output, drag the
appropriate yellow icon to the grey OUT icon
that will be used as the d rive enable output. Its
color will change to bright blue.