Filter
Top Products
Basic Installation 3-1MN1904
3.1 Introduction
You should read all the sections in Basic Installation.
It is important that the correct steps are followed when installing the NextMove BX
II
.This
section describes the mechanical installation and power requirements of the NextMove BX
II
.
3.1.1 Power sources
An external (customer supplied) 24VDC logic supply is required. This must be a regulated
power supply capable of providing:
H 24VDC ±20% at approximately 700mA (max) for the logic power supply
H 12 to 24VDC ±20% at approximately 400mA (max) for the isolated outputs
H 12 to 24VDC ±20% at approximately 200mA for the isolated digital inputs and fast
interrupts.
A 24V filter may be required to comply with the CE directive for which the NextMove BX
II
was
tested.
3.1.2 PC Hardware requirements
A PC that fulfills the following specification will be required:
Minimum specification Recommended specification
Processor Intel Pentium 133MHz Intel Pentium 200MHz or faster
RAM 32MB 64MB
Hard disk space 40MB 60MB
CD-ROM ACD-ROMdrive
Screen 800 x 600, 256 colors 1024 x 768, 256 colors
Mouse A mouse or similar pointing device
Operating system Windows 95, Windows 98, Windows ME,
Windows NT, Windows 2000 or Windows XP
3 Basic Installation
3