Filter
Top Products
Teledyne API - T300/T300M and M300E/EM PN 04906H (DCN5840) APPENDIX A-3: Warnings and Test Functions
A-21
APPENDIX A-3: Warnings and Test Functions
Table A-2: T300/T300M and M300E/EM Warning Messages, Revision L.8
Name
1
Message Text Description
Warnings
WSYSRES SYSTEM RESET
Instrument was power-cycled or the CPU
was reset.
WDATAINIT DATA INITIALIZED Data storage was erased.
WCONFIGINIT CONFIG INITIALIZED
Configuration storage was reset to factory
configuration or erased.
WCONCALARM1 CONC ALARM 1 WARN Concentration limit 1 exceeded.
WCONCALARM2 CONC ALARM 2 WARN Concentration limit 2 exceeded.
WSOURCE SOURCE WARNING
Reference reading minus dark offset
outside of warning limits specified by
REF_SOURCE_LIMIT variable.
WAUTOZERO
4, 5
AZERO WARN 1.001
Auto-reference ratio below limit specified
by ZERO_LIMIT variable.
WBENCHTEMP BENCH TEMP WARNING
Bench temperature outside of warning
limits specified by BENCH_SET variable.
WWHEELTEMP WHEEL TEMP WARNING
Wheel temperature outside of warning
limits specified by WHEEL_SET variable.
WO2CELLTEMP
10
O2 CELL TEMP WARN
O
2
sensor cell temperature outside of
warning limits specified by O2_CELL_SET
variable.
WSAMPFLOW
6
SAMPLE FLOW WARN
Sample flow outside of warning limits
specified by SAMP_FLOW_SET variable.
WSAMPPRESS SAMPLE PRESS WARN
Sample pressure outside of warning limits
specified by SAMP_PRESS_SET
variable.
WSAMPTEMP SAMPLE TEMP WARN
Sample temperature outside of warning
limits specified by SAMP_TEMP_SET
variable.
WPURGEPRESS
9
PURGE PRESS WARN
Purge pressure outside of warning limits
specified by PURGE_PRESS_SET
variable.
WBOXTEMP BOX TEMP WARNING
Internal box temperature outside of
warning limits specified by BOX_SET
variable.
WBOXTEMP2
4
BOX TEMP2 WARNING
Internal box temperature #2 outside of
warning limits specified by BOX2_SET
variable.
WOVENTEMP
11
OVEN TEMP WARNING
Oven temperature outside of warning
limits specified by OVEN_SET variable.
WPHOTOTEMP PHOTO TEMP WARNING
Photometer temperature outside of
warning limits specified by
PHOTO_TEMP_SET variable.
WDYNZERO CANNOT DYN ZERO
Contact closure zero calibration failed
while DYN_ZERO was set to ON.
WDYNSPAN CANNOT DYN SPAN
Contact closure span calibration failed
while DYN_SPAN was set to ON.
WREARBOARD REAR BOARD NOT DET
Rear board was not detected during
power up.
04188D DCN5752