Filter
Top Products
DB2 Manager User Guide 153
StorageTek Proprietary
OTD20083 Task tnnn has not been purged – request ignored
Explanation: A FORCE request has been entered for task 'tnnn', where ‘t’ identifies
the sub-task type (‘D’ – disk reader; ‘H’ – housekeeping; ‘S’ –
scheduler; ‘T’ – tape reader; ‘W’ – writer) and ‘nnn’ gives the sub-task
number, but no prior PURGE request has been entered. A PURGE
request must already have been entered for a task before a FORCE
request is accepted. The request is ignored.
Action: Enter a PURGE request for the task. All outstanding retrieval
requests will be completed before the specified task is terminated. If
necessary a FORCE request may then be entered for the task.
OTD20091 Invalid Shutdown operand(s)
Explanation: An invalid operand has been entered with the operator SHUTDOWN
command.
Action: Re-enter the command, specifying a valid operand. Refer to page 62
for details of the operator SHUTDOWN command format.
OTD20092 Do you want to proceed with shutdown (y/n)?
Explanation: An operator SHUTDOWN request has been entered on the console
via the operator reply facility. This message is displayed to ask for
confirmation of the shutdown request.
Action: To proceed with DB2 Manager control region shutdown processing,
enter 'Y'.
To abort the shutdown request, enter 'N'. The operator reply message
OTD20000 will then be redisplayed.
OTD20093 Shutdown in progress
Explanation: An operator SHUTDOWN request has been entered and accepted.
Termination of the control region will continue.
Action: None. This is an informational message only.
OTD20094 Error freeing communications table storage
Explanation: The storage area allocated in subpool 241 in the MVS ECSA during
control region initialization processing for the DB2 Manager
communications table was not freed successfully during control region
shutdown. Termination processing continues.
Action: Refer to other available system messages for more information
regarding the error. When the cause has been identified, take the
appropriate corrective action to ensure that the error does not re-
occur during future shutdown of the control region.