Filter
Top Products
DB2 Manager User Guide 147
StorageTek Proprietary
Explanation: ‘COMMAND=MODIFY’ is set in the Archive Manager/OAM
TAPECNTL parameter library member, but an MVS command other
than ‘MODIFY’ has been issued to the DB2 Manager control region.
Action: Re-enter the DB2 Manager command using the standard MVS
MODIFY command structure. Refer to “DB2 Manager operator
interface” on page 50 for more information on entering DB2 Manager
control region commands.
OTD20033 I/O error X'xxxx' processing ENVCNTL | TAPECNTL parameter
member
Explanation: An I/O error has occurred processing the identified member from the
DB2 Manager parameter library during control region initialization
processing. 'xxxx' gives the first two sense bytes from the IOB at the
time of the error. Control region initialization is aborted.
Action: Refer to IBM documentation for a description of the error code. Take
the appropriate corrective action and restart the control region.
If no apparent cause for the error can be detected, contact your DB2
Manager product support representative.
OTD20034 Error X’xx’ received loading program XXXXXXXX
Explanation: An error has occurred dynamically loading the program identified in
the message. ‘xx’ gives the hexadecimal error record received from
the LOAD request.
Action: Refer to IBM macro documentation for a description of the error code
in the message. Ensure that the program identified in the message is
available to be loaded from the steplib, joblib or linklist concatenation.
Consult other available system messages for additional information on
the load error. Take the appropriate corrective action and restart the
control region.
OTD20049 Task tnnn shutdown request has failed - error X'xx'
Explanation: Shutdown of a sub-task has failed during control region termination
processing. ‘xx’ gives the hexadecimal return code from the DETACH
macro. ‘t’ identifies the sub-task type (‘D’ – disk reader; ‘H’ –
housekeeping; ‘S’ – scheduler; ‘T’ – tape reader; ‘W’ – writer) and
‘nnn’ gives the sub-task number. Termination of the control region
continues.
Action: None. This is an informational message. System abend ‘A03’ may
be received on termination of the control region after display of this
message.
OTD20050 Missing or invalid request - ignored