Filter
Top Products
132 DB2 Manager User Guide
StorageTek Proprietary
Explanation: Identification of objects to be pre-fetch by Archive Manager cannot be
performed via index-only processing, and a SQLIN parameter of
INDEXONLY=Y has been specified (or defaulted). Execution of the
utility cannot continue, and is terminated with a condition code 12.
Action: Refer to a description of the INDEXONLY execution parameter on
page 101 for a discussion of considerations regarding index-only
processing by the row restore utility. If necessary, change the setting
of the INDEXONLY parameter and re-submit the job.
OTD13015 Archive Manager is not at the correct level
Explanation: Archive Manager v2.6 or higher must be installed in order to be able
to perform pre-fetch processing using the DB2 Manager pre-fetch
utility. The version of Archive Manager used during execution of the
utility is not at the correct level.
Action: Ensure that the correct Archive Manager load library has been
specified in the STEPLIB, JOBLIB or linklist library concatenations,
and rerun the job.
OTD13016 Return Code xx, Supp codes X'yyyyyyyy' received during OPEN |
CLOSE processing for Archive Manager database zzzz
Explanation: An error has been received from an Archive Manager open or close
request. ‘xx’ gives the return code and ‘yyyyyyyy’ the hexadecimal
supplementary reason codes received from Archive Manager.
Execution of the utility has been terminated with condition code 12.
Action: Refer to the Archive Manager User Manual for a description of the
return and supplementary codes displayed in the message. Take the
appropriate corrective action and re-submit the job. If no obvious
reason for the error can be identified, contact your local STK support
representative.
OTD140xx – table analysis utility messages
Messages from the DB2 Manager table analysis utility will be written to the SYSPRINT
dataset.
OTD14000 Table Analysis Utility ended with completion code xx
Explanation: The DB2 Manager table analysis utility has terminated. ‘xx’ gives the
job completion code. This can take the following values:
0 - the utility has been executed successfully.
4 - a warning condition has been encountered during processing of
the utility. A warning message will have been written to the