Filter
Top Products
142 DB2 Manager User Guide
StorageTek Proprietary
OTD20007 ENVCNTL | TAPECNTL parameters successfully processed
Explanation: Validation of parameters in the ENVCNTL or TAPECNTL member of
the DB2 Manager parameter library has completed successfully.
Control region initialization processing continues.
Action: None. This is an informational message.
OTD20008 ODCT GETMAIN failure x'xxxx'
Explanation: A request for virtual storage in subpool 241 of the MVS ECSA has
been denied by the operating system with return code 'xx'.
Initialization of the control region is aborted.
Action: Refer to IBM documentation on the GETMAIN macro for an
explanation of the return code. Take the appropriate corrective action
and restart the control region.
OTD20009 Communications table initialized
Explanation: The DB2 Manager communications table has been successfully
initialized during control region initialization. Processing continues.
Action: None. This is an informational message.
OTD20010 Error X'xx' during initialization of task tnnn
Explanation: Error code 'xx' was returned by a sub-task during Archive
Manager/OAM initialization processing. Control region initialization
has been aborted. ‘t’ identifies the sub-task type (‘D’ – disk reader;
‘H’ – housekeeping; ‘S’ – scheduler; ‘T’ – tape reader; ‘W’ – writer)
and ‘nnn’ gives the sub-task number.
Action: Consult other messages displayed during control region initialization
for a description of the sub-task error. Take the action specified for
the error message, and restart the control region.
If the cause of the error is not apparent from any displayed message,
contact your DB2 Manager product support representative.
OTD20011 Timeout error during initialization of task tnnn
Explanation: A control region sub-task has not responded with one minute during
initialization processing. Initialization of the control region has been
aborted. ‘t’ identifies the sub-task type (‘D’ – disk reader; ‘H’ –
housekeeping; ‘S’ – scheduler; ‘T’ – tape reader; ‘W’ – writer) and
‘nnn’ gives the sub-task number.
Action: Consult other messages displayed during control region initialization
for possible information as to why the sub-task is not responding.
Take the action specified for the error message, and restart the
control region.