Filter
Top Products
22 C1307M-C (8/07)
AZ/EL LINE
Az/El Line controls the vertical display position of the Azimuth/Elevation label. You can display the label on lines 3 through 10.
Line 3 is the third line from the top of the screen; line 10 is located at the bottom of the screen. The default is 10.
NOTES:
• Az/El display is not available while you are programming or running a pattern.
• Use different horizontal position and line settings for Az/El, Direction, and Zoom. Otherwise, the labels may overwrite one another.
To program the vertical label position for Az/El:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside <Other>. Press the Iris Open button; the menu appears.
3. Position the cursor (>) beside <Az/El/Direction>. Press the Iris Open button; the menu appears.
4. Position the cursor (>) beside Az/El Line. Press the Iris Open button; the cursor moves to the right.
5. Move the joystick up or down to view the available selections.
6. Do one of the following:
• Select: Press the Iris Open button to select the option.
• Cancel: Press the Iris Close button to leave the setting as is.
Set Azimuth Zero
Az/El Left
Az/El Line 10
Direction Right
Direction Line 10
Zoom Center
Zoom Line 10
Disp Duration 2
Exit
Az/El/Direction
Temp Units Celsius
Park time minutes 0
Scan Speed deg/s 7
Pattern Length 1.5 min
Spd Profile 90 MPH Wind
<Zone Blank>
<Az/El/Direction>
Exit
Other Menu
<Camera>
<Power Up Mode>
<Limit Stops>
<Other>
<System Information>
<Factory Defaults>
Exit
MAIN MENU